HBM 人体模型

产品概要：

• ±6 kV Human-Body-Model (HBM) 2-pin tester probe-head according ANSI/ESDA/JEDEC JS-001 standard with C=100 pF, R=1.5 kΩ discharge network

• Optionally available upgrade for all HPPI TLP-3010C,4010C, 8010A/C, and TLP-12010A/C hardware systems and software (upgrade on request)

• True HBM– the classical discharge network of the HBM-S1-B according the normative standard ensures compliant waveforms for all load conditions

• Suppression of trailing pulses

• Integrated charge removal resistor

• Integrated DUT voltage and DUT current sensor for realtime voltage and current monitoring

• Integrated DC test DUT switch

• Integrated hardware 50Ω trigger output for high speeddigital oscilloscopes

• Integrated overvoltage protection of voltage sense, current sense and DC test interfaces for oscilloscope and SMU protection during high voltage HBM testing

• Fast and efficient HBM measurements including transient waveform data management using the standard HPPI TLP software

• Compact size 145 mm x 82.5 mm x 44 mm

基本信息：

The HBM-S1-B is a 2-pin HBM test probehead according ANSI/ESDA/JEDEC JS-001 standard with C=100 pF, R=1.5 kΩ discharge network up to ±6 kV. The HBM-S1-B can be used as an optional extension (upgrade on request) for all HPPI TLP-3010C, 4010C, 8010A/C, and TLP-12010A/C pulse generators to provide VF-TLP/TLP/HMM and HBM in a single test system. All modes are operated using the same software for efficient and fast transient waveform and data management as well as automatic probe station control for measurement of wafer statistics. The software provides also a JEDEC HBM verification test procedure including automated report generation in order to check the compliance of the HBM pulse unit with the normative standard Fig. 1, and Fig. 2(a) respectively, show the schematic diagram of the HBM-S1-B and its typical output pulse waveforms at 6 kV, short circuit and 500Ωload. Fig. 2(b) shows the output signal on a longer time axis of 2 ms with no trailing pulses.

 

All functions for DUT current sense, DUT voltage sense and DC test are integrated. The current sensor is located at the high potential side of th epulse output in order to catch the total DUT current1 . The integrated hardware 50Ω trigger output for high speed digital oscilloscopes ensures reliable triggering for all load (DUT) conditions. This is especially important for automatic waferlevel measurements.

 

Fig. 1 shows a typical 2-pin measurement setup, which can be configured for waver-level as well as package level measurements. Also a Kelvin-setup can be applied in order to measure the DUT voltage accurately.

技术优势：

应用方向：

先进的TLP/HMM/HBM解决方案，±6 kV ANSI/ESDA/JEDEC 2引脚HBM测试仪。

HBM 人体模型

HBM 人体模型

HBM 人体模型

HBM 人体模型